6 Series 635d (M57T2) Coupe
Release banjo bolt (1) and detach pressure line (2) from vane
pump.
Installation:
Replace all sealing rings.
Make sure pressure line is laid without tension and with sufficient
spacing to adjoining components.
Tightening torque 32 41 3AZ
.
Release hose clamp (5) and detach suction line (4) from vane
pump.
Installation:
Markings (3) on suction line and vane pump connection must
match up.
Release screws (1, 2) and remove power steering pump towards
top.
Installation:
Provisionally fasten vane pump with screws (1 - 2) (do not tighten
down screws).
Tighten down screws (1).
Tightening torque 32 41 1AZ
.
Tighten screw (2).
Tightening torque 32 41 1AZ
.
After installation:
•
Fill and bleed hydraulic system
•
Check pipe connections for leaks
RA Removing and installing (replacing) vane pump for power steering (M57T2)
BMW AG - TIS
21.01.2013 23:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
