6 Series 635d (M57T2) Coupe
41 13 ...
Partial replacement, bulkhead, right (engine
carrier front section removed)
Read contents of Body, General.
The reduced-weight aluminum front end structure (GRAV) is used
on this vehicle.
Observe specific procedure.
Following new body parts are required (refer to EPC):
-
(1) Bulkhead
Open rivet joints in areas (1) and (2).
Installation:
Use 8 rivets (size 13) in area (1).
Use 1 rivet (size 13) in area (2).
Mark severance cut (1) in accordance with measurements a and b
and cut bulkhead.
Measurement a=305 mm
Measurement b=365 mm
Note:
Severance cut (1) runs next to contact surface (2) for engine
carrier front section.
Cut area (2) from engine compartment side.
RA Partial replacement, bulkhead, right (engine carrier front section removed)
BMW AG - TIS
22.01.2013 01:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -