6 Series 645Ci (N62) Coupe
Important!
Do not tilt bearing bracket (1).
Carefully lift out bearing bracket (1).
Place bearing bracket (1) with inlet camshaft and eccentric shaft
as illustrated on special tool 11 9 470 .
Secure bearing bracket (1) with a nut (special tool 11 9 473 ).
Important!
The lower section of the bearing bracket (1) is machined with
the cylinder head and must not be mixed up.
Note:
Lower section of bearing bracket (1) remains on cylinder head.
Note:
This work step will only be necessary if after the inlet camshaft
has been removed the eccentric shaft is also to be removed.
If necessary, remove eccentric shaft sensor (2).
RA Removing and installing/replacing right inlet camshaft (N62 from 9/03 and N62TU)
BMW AG - TIS
18.01.2013 05:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -