6 Series 645Ci (N62) Coupe
Note:
When tightening down screw (1), grip camshaft at hexagon head.
Tighten down screw (1) of inlet adjustment unit.
Tightening torque 11 36 16AZ
.
Release screw (1) and remove special tools 11 9 463 /
11 9 461 from inlet camshaft.
Place special tool 11 9 462 on exhaust camshaft and align
exhaust camshaft so that special tool 11 9 462 rests without a
gap on cylinder head.
Fit special tool 11 9 463 , secure screw (1) in thread for oil line
and tighten down by hand.
RA Removing and installing/replacing inlet and exhaust adjustment units on left sid
BMW AG - TIS
18.01.2013 05:55
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 8 -