6 Series 645Ci (N62) Coupe
Release hose clamp (1) and detach suction line from power
steering pump.
Unscrew nut (3).
Tightening torque, 32 41 6AZ
.
Release banjo bolt (2) and detach pressure line
for Dynamic Drive from power steering pump.
Release banjo bolt (4) and disconnect pressure line for power
steering from power steering pump.
Installation:
Replace all sealing rings.
Make sure hydraulic lines are laid without tension and with
sufficient spacing to adjoining components.
Tightening torque 32 41 3AZ
.
Version with active front steering: Disconnect plug
connection (1).
Release screw (2).
Tightening torque 32 41 1AZ
.
Variant (A) - build date up to 05/2004:
Release screws (1, 2).
Tightening torque 32 41 1AZ
.
Remove power steering pump (3) downwards.
Variant (B) - build date from 05/2004:
Release bolt (1) and nut (2).
Tightening torque 32 41 1AZ
.
Remove power steering pump (3) downwards.
After installation:
•
Fill and bleed hydraulic system
•
Check pipe connections for leaks
•
Carry out steering angle sensor adjustment/adjustment for
active front steering
•
If necessary, carry out initial Dynamic Drive operation
RA Removing and installing/replacing power steering pump for power steering gear wi
BMW AG - TIS
18.01.2013 07:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
