6 Series 645Ci (N62) Coupe
33 21 000
Removing and installing/replacing left or right
output shaft
Remove rear wheel.
Important!
Expand turning lock sufficiently to avoid damaging thread
when releasing collar nut.
Release collar nut, activate handbrake for this purpose.
Installation:
Replace collar nut, oil collar nut/wheel bearing contact surface
lightly and tighten down.
No oil permitted on thread of shaft journal or collar nut.
Tightening torque 33 41 3AZ
.
Secure collar nut by positive peening on flat areas of output shaft.
Remove exhaust system.
Release bolts and remove with washers (1).
Force output shaft off drive flange with a suitable tool.
Installation:
Before installing output shaft, make sure that drive flange is fully
engaged in rear differential.
Replace bolts and washers (1).
Tightening torque 33 21 1AZ
.
RA Removing and installing/replacing left or right output shaft
BMW AG - TIS
18.01.2013 08:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -