6 Series 645Ci (N62) Coupe
Remove sealing ring carefully with a plastic needle.
Clean cylinder bores and parts with alcohol and dry with
compressed air.
Thoroughly inspect cylinder bore, piston and flange surfaces.
Machining of cylinders and pistons is not permitted.
Installation:
Apply a light coat of Ate brake cylinder paste to cylinder bore,
piston and sealing sleeve,
Refer to BMW Service Operating Fluids.
Install sealing cover in rear annular groove of cylinder bore.
Press in piston with a hardwood board.
Important!
Do not tilt piston.
Press on dust protection sleeve evenly up to stop with special tool
34 1 133 .
Installation:
The area between dust protection sleeve and brake caliper
housing must be kept dry so as to ensure correct seating for
the dust protection sleeve.
Keep Ate brake cylinder paste or brake fluid away from this
area.
Make sure dust protection sleeve is correctly seated on
piston.
RA Overhauling left or right front brake caliper (brake caliper removed)
BMW AG - TIS
18.01.2013 08:20
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -