6 Series 650i (N62TU) Coupe
12 42 500
Removing and installing or replacing battery
positive lead (between alternator, starter and
battery positive terminal) (N62)
Work step
Note:
Switch off ignition.
Disconnect negative battery lead.
Follow instructions for disconnecting and
connecting battery.
Remove suction filter housing.
Remove right fresh air duct.
Remove centre equipment compartment heater bulkhead.
Remove intake air manifold.
Remove A/C compressor drive belt.
Detach battery positive lead from alternator.
Tightening torque 12 31 1AZ.
Lift engine hood into assembly position.
Secure engine in installation position with special tool.
Release grounding strap on engine support arm.
Release A/C compressor and place to one side.
Remove exhaust system
Remove right exhaust manifold.
Lower front axle.
Remove starter motor.
Tightening torque 12 41 4AZ.
Detach battery positive lead from support point/terminal.
Tightening torque 12 42 1AZ.
Unclip battery positive lead (2) from holders (1).
Installation:
Make sure battery positive lead is in correct installation position.
Danger of short circuits.
RA Removing and installing or replacing battery positive lead (between alternator,
BMW AG - TIS
18.01.2013 22:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
