6 Series 650i (N62TU) Coupe
13 62 010
Removing and installing/replacing differential
pressure sensor (N62, N62TU)
Necessary preliminary tasks:
•
Read out fault memory of Digital Motor Electronics (DME)
control unit; if necessary, work through test schedules
•
Switch off ignition
Work step
Note:
Installation location:
On rear side of intake air manifold.
Remove design cover.
E65/E66 only
Remove acoustic cover.
Remove both lower microfilter housing sections.
E60/E61/E63/E64 only
Remove engine compartment bulkhead.
E65/E66 only
Remove cover for ignition coils on left and right.
Unlock and disconnect following plug connections.
-
Fuel rail, left and right, on cable duct
-
Throttle-valve assembly
-
Knock sensor, left and right
-
All solenoid valves
-
Both temperature sensors
-
Oil-pressure switch
-
Tank venting valve
-
Alternator
-
Valvetronic servomotor, left and right
-
Pulse generator on exhaust and inlet camshafts, left and right
-
Eccentric shaft sensor, left and right
Lines to oxygen sensors remain
connected.
Lines to electronics box remain
connected.
RA Removing and installing/replacing differential pressure sensor (N62, N62TU)
BMW AG - TIS
18.01.2013 22:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
