6 Series 650i (N62TU) Coupe
31 11 506
Lowering/raising front axle carrier
Special tools required:
•
00 2 030
•
00 2 040
•
31 4 012
•
33 3 274
Warning!
Danger to life!
Secure engine in installation position to prevent it from falling
down.
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Seal off hydraulic lines with plugs.
Necessary preliminary tasks:
•
Secure engine in installation position
•
Remove reinforcement plate
•
Remove steering gear cover on both sides
•
Remove lower steering spindle from power steering gear
•
If necessary, disconnect plug connection on EH converter
and expose line up to engine carrier
•
If necessary, disconnect plug connection on ride-height
sensor and expose line up to engine carrier
Version with Dynamic Drive:
Draw off and dispose off hydraulic fluid from fluid reservoir.
Observe country-specific waste-disposal regulations
Remove bottom right wheel arch trim.
Release nut (1) for Dynamic Drive return line.
Tightening torque 37 14 21AZ
.
Release nut (2) for Dynamic Drive pressure line.
Tightening torque 37 14 13AZ
.
Release nuts (3) for pressure lines to front axle oscillating motor.
Tightening torque 37 14 13AZ
.
RA Lowering/raising front axle carrier
BMW AG - TIS
18.01.2013 23:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
