6 Series M6 (S85) Coupe
Note:
Check conrod bearing clearance.
Piston in BDC position.
Place special tool 00 2 590 (Plastigage model PG 1) on oil-free
crankshaft.
Place bearing caps in position, making sure that matching
numbers are paired.
Important!
Do not distort conrods or crankshaft.
Use the old conrod bearing bolts to check conrod clearance.
Tighten down conrod bolts with special tool 00 9 120 .
Tightening torque: 11 24 1AZ
.
Remove conrod bearing cap and read off bearing clearance at
width of pinched plastic thread on measuring scale.
Conrod bearing clearance: Refer to Technical Data.
•
Remove plastic thread.
•
Lubricate crankshaft and bearing shells.
•
Install new conrod bolts and tighten down.
Tightening torque: 11 24 1AZ
.
Assemble engine.
RA Replacing all connecting rod bearings (S85)
BMW AG - TIS
19.01.2013 13:17
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
