6 Series E64 630i (N52) CONVER
18 40 060
Removing and installing/replacing rear
exhaust manifold (N52)
Necessary preliminary tasks:
•
Remove reinforcement plate
•
Remove complete exhaust system
Note:
The oxygen sensors are in danger of being damaged when the
exhaust manifolds are removed and installed.
Remove control sensor from cylinders 4 to 6 .
Remove monitor sensor from cylinders 4 to 6.
Unscrew nuts.
Remove exhaust manifold (1).
Installation:
Clean sealing faces, replace gaskets.
Replace nuts.
Tightening torque 18 40 1AZ
.
RA Removing and installing/replacing rear exhaust manifold (N52)
BMW AG - TIS
25.01.2013 22:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -