6 Series E64 630i (N52) CONVER
Installation:
Check that dowel sleeves are correctly seated.
Replace damaged dowel sleeves.
Ensure correct position of cover plate.
Installation:
Check lubrication of transmission input shaft for sticky
consistency. If grease is sticky, replace clutch plate.
Check clutch plate for friction rust in taper splines and replace
if necessary.
Remove any grease and lining abrasion from taper splines of
clutch plate by mechanical means (with a cloth).
Installation:
Greasing specification:
-
Remove and clean release bearing and release lever
-
Push on grease scraper ring 21 2 221 as far as it will go.
-
Grease splines (1) of input shaft with a brush. refer to BMW
Service Operating Fluids
-
Detach grease scraper ring.
Important!
After completing work:
•
Perform adaptation using DIS Tester, refer to Service
Functions in DIS Tester (Teach in transmission)
•
Check transmission oil level
Use only the approved transmission oil
•
Check fluid level in hydraulic system
•
Read out fault memory and clear entered faults
•
Failure to comply with this requirement will result in
serious damage to the manual transmission!
RA Removing and installing transmission (GS6S37BZ SMG) N52
BMW AG - TIS
26.01.2013 00:37
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -