6 Series E64 630i (N52) CONVER
51 71 482
Removing and installing/replacing left or right
tension strut (on rear axle)
Special tools required:
•
00 9 120
Important!
Observe safety instructions for raising the vehicle.
Do not drive vehicle without tension strut installed; failure to
comply with this instruction will result in damage to the body!
Release screws (1) and nuts (2).
Remove tension strut (3).
Installation:
Replace screws (1).
Tighten down screws (1) and then retighten to angle of rotation
using special tool 00 9 120 .
Tightening torque 51 61 3AZ
.
RA Removing and installing/replacing left or right tension strut (on rear axle)
BMW AG - TIS
26.01.2013 02:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -