6 Series E64 630i (N52) CONVER
34 31 505
Removing and installing / replacing master
brake cylinder for DSC
Special tools required:
•
32 1 270
Necessary preliminary tasks:
•
Remove expansion tank.
•
Remove footwell trim.
•
Read and comply with General Information.
After completing tasks, bleed brake system with DSC.
Remove locking clip (1) and disengage and pull out locking pin.
Slacken nuts (2).
Installation:
Replace self-locking nuts.
Tightening torque 35 11 1AZ
.
Unfasten brake lines (1).
Detach brake lines at junction (2) and remove short sections.
Seal off brake lines and brake master cylinder with plugs
32 1 270 .
Installation:
Fit lines at both connection points and then tighten down.
Tightening torque 34 32 1AZ
.
Release nuts (3) and feed brake master cylinder out of brake
booster.
RA Removing and installing / replacing master brake cylinder for DSC
BMW AG - TIS
26.01.2013 03:22
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -