6 Series E64 630i (N52) CONVER
37 10 005
Removing and installing/replacing vent hose
for active stabilizer (front)
Necessary preliminary tasks:
•
Remove front assembly underside protection
Distribution hose:
Release nuts (1).
Tightening torque 37 11 2AZ
.
Withdraw vent line (3) from distribution hose (2).
Remove distribution hose (2).
Vent hose:
Withdraw seal plug (1) from front axle carrier.
Remove vent line with filter from front axle carrier.
Observe the following when replacing vent valves:
Release vent valves (1).
Installation:
Push distribution hose (2) into vent valves (1) up to middle
between markings (M).
Tightening torque 37 11 1AZ
.
Screw vent valves (1) completely into oscillating motor.
Remove assembly plugs from both vent valves (1).
RA Removing and installing/replacing vent hose for active stabilizer (front)
BMW AG - TIS
26.01.2013 03:51
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
