6 Series E64 630i (N52) CONVER
Carefully lever trim (1) with special tool
00 9 321 off
convertible top compartment lid (2). The all-round adhesive tape
tears in the process.
Important!
When levering off, avoid contact with edges on trim (1) (risk
of damage).
Remove trim (1) and seal between trim and convertible top
compartment lid.
Set trim (1) down on a clean surface.
Roughly remove remnants of adhesive tape (1) from convertible
top compartment lid and when refitting from trim (2) with special
tool 00 9 321 .
Remove remnants of adhesive layer (1) with grinding wheel (2)
and adhesive remover (source reference: BMW Parts Service).
Important!
Bonding surface must be dry and free of dust and grease.
Once it has been cleaned, do not touch the adhesive area
with bare hands.
Replacement:
If necessary, fit new seals on convertible top compartment lid on
left or right.
When refitting:
Use template (2) provided to attach adhesive tape (1) (ingress
of water).
Use template (2) for left and right sides (turn round).
Installation:
Place template (2) over prepunched holes (3) and straight
edge (4) in direction of travel and secure in position.
RA Removing and installing/replacing trim on convertible top compartment lid
BMW AG - TIS
26.01.2013 06:25
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -