6 Series E64 630i (N52) CONVER
Remove toothed segment cover (1) as follows:
•
Raise cover in upward direction
•
Slide cover upwards and detach
Note:
Before removing the backrest, it is essential to move the backrest
forwards:
Pull Bowden cable (1) and press backrest forwards.
Remove backrest frame from seat mechanism as follows:
Lever tunnel-side backrest frame with screwdriver over bushing.
Then remove backrest frame in upward direction by pulling with
alternate movements.
Tunnel-side plastic bushing (1) must not be damaged.
Disengage return spring (1).
Installation:
Replace return spring (1).
Note:
Cover working area.
Do not allow any chips to get into the seat and backrest
mechanisms.
Mark rivet (2) with centre punch and drill out.
RA Replacing backrest release cable for front left or right seat
BMW AG - TIS
26.01.2013 07:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -