6 Series E64 630i (N52) CONVER
54 34 034
Removing and installing/replacing complete
hydraulic system for convertible top
Necessary preliminary tasks:
•
Remove hydraulic cylinder for convertible top
•
Remove hydraulic cylinder for convertible top compartment lid
•
Remove hydraulic cylinder for clamping bar
Note:
Hydraulic circuit remains closed during this operation.
Release Torx screws.
Installation:
Replace Torx screws and insert with Loctite.
If necessary, disconnect cable straps from hydraulic lines.
Remove hydraulic unit (1) with hydraulic system.
RA Removing and installing/replacing complete hydraulic system for convertible top
BMW AG - TIS
26.01.2013 08:13
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -