6 Series E64 630i (N52) CONVER
54 34 100
Adjusting convertible top
Special tools required:
•
54 3 000
Note:
Observe body gap dimensions for ideal adjustment of convertible
top in relation to body.
Convertible top fins must be vertical during the adjustment
operation.
Convertible top is not screwed down during the adjustment
operation.
Height adjustment:
Turn adjusting sleeves (1) for height adjustment with special
tool 54 3 000 .
(1)
Adjusting sleeves and retaining pins for height adjustment
(2)
Special tool
-
Turn counterclockwise = lower convertible top
-
Turn clockwise = raise convertible top
Longitudinal and lateral adjustment:
The elongated holes on the main bearing allow the convertible top
to be adjusted in the longitudinal and lateral directions.
Note:
After settling procedure, make sure there is a uniform gap
between convertible top (1) and convertible top compartment lid
trim (2).
Gap dimension =
3
±
2 mm
RA Adjusting convertible top
BMW AG - TIS
26.01.2013 08:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -