6 Series E64 630i (N52) CONVER
54 34 005
Removing and installing/replacing hydraulic
unit for convertible top drive
Necessary preliminary tasks:
•
Support convertible top compartment lid in service position
•
Remove side trim panel upper section
Caution!
Hydraulic fluid may emerge from the disconnected lines and
the open connections on the hydraulic unit.
Protect components and work area with suitable materials
(e.g. cloths).
Follow repair instructions for hydraulic system.
Do not fit hydraulic lines in kinked, crushed or transposed
condition.
Unfasten screws.
Installation:
Replace Torx screws and insert with Loctite.
Clip hydraulic unit open.
Remove moulded part.
Disconnect cable straps on left and right.
Installation:
Replace faulty cable straps.
Detach moulded part (1) from hydraulic lines and electrical
cables.
RA Removing and installing/replacing hydraulic unit for convertible top drive
BMW AG - TIS
26.01.2013 08:10
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
