6 Series E64 630i (N52) CONVER
64 11 943
Replacing evaporator temperature sensor
Necessary preliminary tasks:
•
Remove trim panel for pedal assembly.
Release screw (1).
Detach heating duct in rear compartment on left (2) in direction of
arrow from air distributor in footwell (3).
Pull out air distributor in footwell (3) in direction of arrow.
Installation:
Make sure heating duct in rear compartment on left (2) and air
distributor in footwell (3) are correctly seated.
Unscrew bolt (1).
Pull out heating duct in rear compartment on left (2) in direction
of arrow and feed out.
Installation:
Make sure heating duct in rear compartment on left (2) is
correctly seated.
Unfasten plug connection (1) and disconnect.
Pull out evaporator temperature sensor (2) in direction of arrow
and feed out.
Installation:
Ensure evaporator temperature sensor (2) is correctly seated.
RA Replacing evaporator temperature sensor
BMW AG - TIS
26.01.2013 13:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -