6 Series E64 630i (N52) CONVER
Note:
If a seat belt which is damaged due to an accident is exchanged,
always check the retaining bracket of the belt tensioner on the
seat runner for damage and replace if necessary.
A bent seatbelt tensioner retaining bracket on the seat runner may
make it impossible to adjust the height of the seat!
Removing belt tensioner:
Unlock airbag plug connection.
Disconnect plug for pyrotechnical belt tensioner (2).
Remove cable holder with cable (3).
Release screw (1) and remove pyrotechnical belt tensioner.
Installation:
Replace microencapsulated screw.
E46: Tightening torque 72 11 01AZ
.
E64: Tightening torque 72 11 06AZ
.
Installation:
Pin for turning lock (3) must extend into bore hole (1).
Retaining screw of belt tensioner is inserted in bore hole (2).
Installation:
Pin of belt tensioner must snap into place in bore hole of cable
holder.
Make sure cable holder is correctly engaged.
Plug of pyrotechnical belt tensioner must not be under strain.
RA Removing and installing/replacing front seat belt
BMW AG - TIS
26.01.2013 14:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -