6 Series E64 630i (N53) CONVER
21 52 500
Removing and installing/replacing clutch
master cylinder
Note:
After completing work, bleed clutch hydraulic system.
Necessary preliminary tasks:
•
Remove trim panel for pedal assembly.
•
Remove microfilter housing on left.
•
Remove light module.
Draw off brake fluid up to supply hose of clutch hydraulic
system (1). For this purpose, use only a vacuum pipe that is
exclusively used for removing brake fluid.
Detach supply hose (1) from expansion tank.
Disconnect spring (1).
Note:
Illustration shows component removed.
RA Removing and installing/replacing clutch master cylinder
BMW AG - TIS
30.01.2013 07:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -