6 Series E64 630i (N53) CONVER
32 34 020
Removing and installing / replacing airbag
unit
Warning!
Observe the following instructions to avoid any risk of injury by
the airbag unit.
-
Comply with safety regulations for handling components
with gas generators.
-
Do not exert any force on the airbag unit.
-
Use only specified tools for releasing the airbag unit.
Note: Incorrect handling may result in triggering of the airbag
unit and thereby cause serious injury.
Important!
Steering wheel must be replaced if airbag unit has been
triggered!
Follow procedure after airbag triggering.
Necessary preliminary tasks:
•
Disconnect battery negative lead
Insert Torx screwdriver (T25) from below into opening on rear
side of steering wheel until a spring resistance is felt (approx.
3 cm).
Increase pressure on annular spring using Torx
screwdriver (T25) until airbag unit is unlocked on both sides.
Installation:
Make sure connecting cables are correctly routed.
Snap airbag unit with uniform pressing force plane-parallel in
direction of steering column shaft into steering wheel.
RA Removing and installing / replacing airbag unit
BMW AG - TIS
30.01.2013 09:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -