6 Series E64 630i (N53) CONVER
Pull out power window unit (1) towards top slightly.
Lift out cable holder (2) from power window unit (1).
Lever out grommet (3) from side panel.
Disconnect plug connection (4) on flat motor (5).
Remove power window unit (1).
Presettings after fitting power window unit:
Preset dimension (A) at power window unit (1) (window glass
breakage); only then may the power window unit (1) be actuated.
Dimension (A) = 18.5 mm
Close window completely.
Check gap dimension (B) between door window (1) and flange
on side panel (2).
Dimension (B) = 7.7 mm
Open convertible top and convertible top compartment lid.
Fit window cavity cover (1).
Preset dimension (C) between window cavity cover (1) and
flange on side panel (2).
Dimension (C) = 24 mm
Installation:
Check function.
Adjust rear side window.
RA Removing and installing complete rear left or right power window unit
BMW AG - TIS
30.01.2013 13:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -