6 Series E64 630i (N53) CONVER
Feed in special tool 51 3 057 behind top edge of cover (1) and
pass along edge towards front and rear. Press tool/cover edge
upwards towards outside (above all in area of engaged retaining
lugs (2)).
Remove cover to side slightly.
Disconnect plug connection.
Remove cover.
Installation:
Retaining lugs and tabs must not be damaged, replace cover if
necessary.
Do not crush plug when fitting cover.
Replacement of actuating unit only:
Raise tabs (1) slightly and detach actuating unit (2).
Installation:
Tabs and catches of actuating unit must not be damaged.
Replacement of lumbar support switch only:
Press catches (1) on left/right to one side and
remove switch (2).
Removing and installing/replacing rear left cover
Necessary preliminary tasks:
•
Remove carrier for front cover
RA Removing and installing/replacing outer covers on left or right front seat (spor
BMW AG - TIS
30.01.2013 13:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -