6 Series E64 630i (N53) CONVER
54 34 159
Removing and installing left convertible top
fastener
Necessary preliminary tasks:
•
Remove cowl panel trim (convertible top fastener)
Detach cable strap (2).
Lever out retaining ring and detach ball socket (3).
Note:
Do not misadjust control element.
If necessary, adjust (tension) control element.
Left convertible top fastener only:
Unfasten plug connection (1) and disconnect.
Unfasten screws.
Installation:
Replace Torx screws and insert with Loctite.
Pull flex shaft (1) off drive.
Remove convertible top fastener.
Ideal adjustment:
Convertible top must close flush with cowl panel.
Observe gap dimensions.
RA Removing and installing left convertible top fastener
BMW AG - TIS
30.01.2013 15:43
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -