6 Series E64 630i (N53) CONVER
Raise locking clip (1) and detach cylinder from ball end.
Disconnect cable straps.
Installation:
Replace faulty cable straps.
Hall sensor line must be tied with cable straps.
Disconnecting hydraulic lines from cylinder:
Open retainer (1) at bottom/top on cylinder with screwdriver.
Detach hydraulic lines (2).
Important!
Protect joints (lines and cylinder) against dripping fluid, e.g.
with a cleaning cloth.
Observe hose markings.
Left hydraulic cylinder only:
Release screw (3) and remove Hall sensor.
Installation:
Make sure metal angle is correctly installed under Hall sensor.
RA Removing and installing/replacing left hydraulic cylinder for convertible top co
BMW AG - TIS
30.01.2013 15:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
