6 Series E64 635d (M57T2) CONVER
32 41 332
Replacing pressure line for power steering
(M57T2)
Warning!
Danger of poisoning if oil is ingested/absorbed through the
skin!
Risk of injury if oil comes into contact with eyes and skin!
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Close off pipe connections with plugs.
Recycling:
Catch and dispose of hydraulic fluid in a suitable container.
Observe country-specific waste-disposal regulations
Necessary preliminary tasks:
•
Draw off and dispose of hydraulic fluid from fluid reservoir
•
Remove acoustic cover at front
•
Remove front underbody protection
•
Remove steering gear cover at side
Important!
Cover alternator with a suitable covering to prevent ingress of
hydraulic fluid.
Release banjo bolt (1) and detach pressure line (2) from vane
pump.
Installation:
Replace all sealing rings.
Make sure pressure line is laid without tension and with sufficient
spacing to adjoining components.
RA Replacing pressure line for power steering (M57T2)
BMW AG - TIS
02.02.2013 23:48
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
