6 Series E64 635d (M57T2) CONVER
Note:
Leave retaining bracket screwed down on rollover protection.
Stop for adjusting rear window module.
Release screws (1).
Tightening torque 51 17 19AZ
.
Installation:
Replace all Torx screws and insert with Loctite.
Release left and right screws (1).
Remove cover (2) on left and right.
Note:
Before releasing screws (2), mark position to ensure correct
alignment during installation.
Loosen screws (2).
Tightening torque 54 34 9AZ
.
Release left and right screws (1).
Installation:
Replace all Torx screws and insert with Loctite.
Remove rear window module (1) from convertible top main
bearing.
Installation:
Align rear window module to marking and adjust if necessary.
If necessary, adjust seal on convertible top compartment lid.
RA Removing and installing/replacing rear window module
BMW AG - TIS
03.02.2013 04:56
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
