6 Series E64 635d (M57T2) CONVER
67 61 531
Removing and installing/replacing drive for
convertible top fastener
Necessary preliminary tasks:
•
Move convertible top compartment lid into service position
•
Remove cowl panel trim
Unhook drive shafts (1) and (3) from mounts (5) and (4).
Pull off drive shafts (1) and (3) in direction of arrow from drive
for convertible top fastener (2).
Installation:
Do not mix up drive shafts (1) and (3), pay attention to relevant
markings.
Installation:
Turn relevant drive shaft (1) to open convertible top lock (2)
completely to outer side of car.
Pull out wiring harness (1) in direction of arrow.
Installation:
Ensure wiring harness (1) is laid correctly.
Turn plug connections (2) completely in direction of arrow and
unclip from fixture (3).
Unlock plug connections (2) and disconnect.
RA Removing and installing/replacing drive for convertible top fastener
BMW AG - TIS
03.02.2013 08:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
