6 Series E64 645Ci (N62) CONVER
Rotate eccentric shaft at dihedral head as shown in illustration and
hold in this position.
Remove cylinder head bolt (7).
Rotate eccentric shaft at dihedral head as shown in illustration
back to minimum stroke position.
Remove remaining cylinder head bolts.
Lift off cylinder head.
Lift off cylinder head gasket.
Installation:
Installation of cylinder head is described separately from removal.
Clean sealing faces of cylinder head and engine block, if
necessary using wooden scraper to remove gasket debris. Make
sure no gasket debris drops into the oil and coolant ducts.
Threaded bores in engine block must be free of dirt and oil (risk of
cracking).
RA Removing and installing left cylinder head (N62 to 9/03)
BMW AG - TIS
04.02.2013 04:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
