6 Series E64 645Ci (N62) CONVER
Ends of compression rings (1) point upwards.
Make sure compression rings (1) are engaged at ends.
Important!
Rocker arms (1) slip slightly when bearing bracket is fitted.
Make sure rocker arms (1) are secured as illustrated on
hydraulic valve clearance compensating elements and on
valves.
Align rockers (1) straight.
Remove special tool 11 9 473 .
Remove bearing bracket (1) from special tool 11 9 470 .
Important!
Do not tilt bearing bracket (1).
Lower bearing bracket (1) from above and carefully bring into
contact with cylinder head.
Insert nuts and tighten by hand without play.
Important!
Make sure none of the intermediate levers or rocker arms
have slipped out.
Tighten down nuts from inside to outside.
Tightening torque 11 31 1AZ
.
RA Removing and installing/replacing left inlet camshaft (N62 from 9/03 and N62TU)
BMW AG - TIS
04.02.2013 04:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 13 -
