6 Series E64 645Ci (N62) CONVER
Insert special tool 11 9 474 and initially tighten without play.
Note:
Special tools 11 9 472 / 11 9 474 and 11 9 475 remain
fitted until all torsion springs and intermediate levers have been
installed.
Note:
Installation of the intermediate levers and torsion springs is
described on the 4th cylinder. The same procedure is applicable
to cylinders 1 to 3.
Attach special tool 11 9 490 to ends of torsion spring.
Install torsion spring (1).
Insert screw (1) and tighten down.
Important!
Intermediate levers (2) are divided into individual tolerance
classes.
Only intermediate levers of the same tolerance class may be
fitted in a single engine.
The tolerance classes are designated as illustrated with the
numbers from 1 to 5.
Used intermediate levers (2) may only be reused in the same
position.
Lubricate all sliding surfaces on intermediate lever (2) with
engine oil.
RA Removing and installing/replacing right inlet camshaft (N62 to 9/03)
BMW AG - TIS
04.02.2013 04:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 11 -
