6 Series E64 645Ci (N62) CONVER
12 31 020
Removing and installing or replacing
alternator (N62)
Switch off ignition.
Follow instructions for disconnecting and connecting
battery.
Disconnect and cover battery negative lead.
Warning!
Danger of scalding!
Only perform these tasks on an engine that has cooled down.
Remove radiator.
Remove alternator drive belt.
Remove A/C compressor drive belt.
Release screws on antifriction bearing on left and right of stabilizer
bar.
Hydraulic lines on oscillating motor remain connected. Do not
release screws on stabilizer link. Remove stabilizer bar with
antifriction bearing from threaded pins and secure against falling
down.
Release holder from hydraulic lines for power steering. Hydraulic
lines on power steering pump remain connected.
Note:
For purposes of clarity, the following work steps are shown on the
engine after it has been removed.
Release screws and remove guide pulley (1).
RA Removing and installing or replacing alternator (N62)
BMW AG - TIS
04.02.2013 05:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
