6 Series E64 645Ci (N62) CONVER
13 62 560
Removing and installing/replacing air-mass
flow sensor (N62, N62TU)
Necessary preliminary tasks:
•
Read out fault memory of DME control unit; if necessary,
work through test schedules
•
Switch off ignition
Open clips (1).
Unlock connector (2) and remove.
Unfasten clip.
Remove top section (3) of intake filter housing.
Installation:
Check sealing ring between air-mass flow sensor and air intake
hose for damage, replacing if necessary.
Unfasten screws.
Pull air-mass flow sensor (1) out of upper section of intake filter
housing.
Note:
Check stored fault messages.
Now clear the fault memory.
RA Removing and installing/replacing air-mass flow sensor (N62, N62TU)
BMW AG - TIS
04.02.2013 05:43
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
