6 Series E64 645Ci (N62) CONVER
Unfasten screws.
Remove and convert transmission bearing block.
Tightening torque 22 32 2AZ
.
Modify following parts to new transmission:
-
Release bearing and release lever
-
Modify cover caps
-
Ball pin and spring wire clip
Installation:
Observe greasing specification.
Add final details to vehicle.
Check transmission oil level.
Important!
After completing work:
-
Perform adaptation using DIS Tester, refer to "Service
Functions" in DIS Tester (Teach in transmission)
-
Check transmission oil level
Use only the approved transmission oil
-
Check fluid level in hydraulic system
-
Read out fault memory and clear entered faults
Failure to comply with this requirement will result in serious
damage to the manual transmission.
RA Installing replacement transmission (GS6S53BZ SMG)
BMW AG - TIS
04.02.2013 06:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
