6 Series E64 645Ci (N62) CONVER
-
Remove propeller shaft from transmission.
-
Release centre bearing.
-
Tie propeller shaft to one side.
Tasks are described in Removing propeller shaft.
Note:
Pressure line of clutch slave cylinder remains connected.
Important!
Slowly relieve tension on clutch slave cylinder otherwise air is
drawn in through sealing sleeve.
Release nuts and remove clutch slave cylinder.
Tightening torque 21 52 5AZ
.
Lever out retainer (1).
Disengage shift rod (2).
Installation:
Grease shift rod.
Grease, refer to BMW Service Operating Fluids.
Make sure shims (3) are in correct position.
Release and remove bearing pins (1) in direction of arrow.
RA Removing and installing transmission (GS6-53BZ) N62/N62TU
BMW AG - TIS
04.02.2013 06:46
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -