6 Series E64 645Ci (N62) CONVER
If necessary, release nut (1) and remove grounding strap.
Release screws (1) and nuts (2) and remove transmission
cross-member.
Tightening torque 22 32 3AZ/4AZ
.
Illustration similar
-
Remove propeller shaft from transmission.
-
Release centre bearing.
-
Tie propeller shaft to one side.
Tasks are described in Removing propeller shaft.
•
Unlock and disconnect plug (1) by turning.
•
Release cable from retainers.
•
Insert special tool 24 2 390 in sealing sleeve.
These tasks are described in Notes on mechatronics.
(Important: Observe important note)
RA Removing and installing automatic transmission (6HP26Z/ N62, N62TU)
BMW AG - TIS
04.02.2013 07:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -