6 Series E64 645Ci (N62) CONVER
Unscrew nut (1).
Remove guide arm from wheel carrier.
Installation:
Keep guide arm to wheel carrier connection clean and free from
oil and grease.
Replace self-locking nut.
Tightening torque 33 32 4AZ
.
Mark position of eccentric screw (3) to rear axle carrier.
Release nut (1) and remove eccentric washer (2).
Pull out eccentric screw (3) and remove guide arm.
Installation:
Note insertion direction of eccentric screw.
Align eccentric screw by means of marking to rear axle carrier.
Refit eccentric washer.
Replace self-locking nut.
Tighten bolt connection in normal position.
Tightening torque 33 32 5AZ
.
After installation:
•
Perform chassis alignment check
RA Replacing a guide arm
BMW AG - TIS
04.02.2013 08:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -