6 Series E64 645Ci (N62) CONVER
Ideal adjustment:
Prerequisite:
•
Convertible top correctly adjusted
•
Convertible top compartment lid correctly adjusted
•
Rear window module correctly adjusted
Note:
It must still just be possible to slide in a paper strip between the
rear window and the seal.
Adjusting seal:
•
Close soft top compartment cover.
•
Close rear window.
•
Slide in paper strip (1) (copier paper = 80 g/m
2
) between
rear window (2) and seal (3).
•
Pull paper strip (1) over entire width of rear window (2).
Note:
It must be possible for the paper strip (1) to be pulled with a slight
friction resistance between rear window (2) and seal (3).
If necessary, move seal (3) until ideal adjustment is obtained.
•
Close convertible top and convertible top compartment lid.
•
Close rear window.
•
Slide in paper strip (3) between rear window (2) and
seal (3).
Note:
It must still just be possible for the paper strip (3) to be slid in
over the entire width of the rear window (2).
If necessary, move seal (1) until ideal adjustment is obtained.
Important!
Seal (1) must not exert excessive pressure on rear
window (2) otherwise the rear window will not be correctly
guided in the side convertible top guides (water ingress/wind
noises).
•
Open convertible top and convertible top compartment lid.
•
Tighten nuts.
Installation:
Tightening torque 51 17 9AZ
RA Removing and installing/replacing middle seal on convertible top compartment lid
BMW AG - TIS
04.02.2013 11:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
