6 Series E64 645Ci (N62) CONVER
Tunnel side:
Release screw (1).
Installation:
Screw (1) must be replaced.
Tightening torque 52 10 14AZ
.
Door side:
Release nut on opposite side from stud (1).
Drive out stud (1) with plastic mallet.
Installation:
Stud (1) and nut must be replaced.
Tightening torque 52 10 15AZ
.
Remove backrest frame from seat mechanism as follows:
Lever tunnel-side backrest frame with screwdriver over bushing.
Then remove backrest frame in upward direction by pulling with
alternate movements.
Tunnel-side plastic bushing (1) must not be damaged.
Backrest mounting on door side:
1.
Install door-side backrest link (1).
2.
Backrest link (1) must be joined centrally on blocking
cam (2).
3.
Connect stud and tighten nut hand-tight.
RA Removing and installing/replacing backrest frame on front left or right seat (no
BMW AG - TIS
04.02.2013 13:04
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -