6 Series E64 650i (N62TU) CONVER
11 12 006
Removing and installing/sealing right cylinder
head cover (N62/N62TU)
(cylinder bank 1 to 4)
Remove design cover
Remove acoustic cover
Remove centre of assembly partition wall
Remove electronics box cover.
Remove electronics box seal.
These work steps are described in the section Replacing control
unit.
Remove ignition coil cover.
Remove intake filter housing (without raw air housing).
Remove intake hose with air-mass flow sensor
Note:
For purposes of clarity, the following work steps are shown on the
engine after it has been removed.
Unlock plug (1) and remove.
RA Removing and installing/sealing right cylinder head cover (N62/N62TU)
BMW AG - TIS
05.02.2013 14:48
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -