6 Series E64 650i (N62TU) CONVER
Tighten screw on inlet adjustment unit without play and then
slacken off again by a half turn.
Get special tool kit 11 9 460 ready for securing camshafts.
Note:
Special tool 11 9 461 for securing inlet camshaft.
Special tool 11 9 462 for securing exhaust camshaft.
Special tool 11 9 463 (holder with screw).
Place special tool 11 9 461 on inlet camshaft and align inlet
camshaft so that special tool 11 9 461 rests without a gap on
cylinder head.
Fit special tool 11 9 463 , secure screw (1) in thread for oil line
and tighten down by hand.
RA Removing and installing/replacing inlet and exhaust adjustment units on right si
BMW AG - TIS
05.02.2013 15:21
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -