6 Series E64 650i (N62TU) CONVER
Eccentric shafts from 2/2003:
Note:
Eccentric shafts of cylinders 1 to 4 and 5 to 8 are identical
parts.
Important!
Note installation direction of eccentric shafts.
Depending on the side on which the magnet wheel is fitted,
the eccentric shafts are used for cylinders 1 to 4 or
5 to 8.
Incorrect assembly will result in engine damage.
Installation of magnet wheel:
Note:
Carefully clamp eccentric shaft (1) as illustrated with protective
jaws (2) in a vice.
Important!
Incorrect assembly will result in engine damage.
Assemble eccentric shaft for cylinder bank 1 to 4:
The machined curvature (3) and the groove in the eccentric shaft
must point forwards as illustrated.
The unmachined surface on the eccentric points to the right.
Secure magnet wheel (1) with lug in eccentric shaft groove.
Important!
Only install original antimagnetic screw (2).
Insert screw (2) and tighten down.
Tightening torque 11 37 1AZ
.
Note:
Replace bearing shells (1) of needle bearings.
Important!
Bearing shells (1) must be installed in such a way that ends
of bearing shells (1) face each other as shown in illustration.
RA Removing and installing/replacing right eccentric shaft (N62 from 9/03 and N62TU
BMW AG - TIS
05.02.2013 15:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -