6 Series E64 650i (N62TU) CONVER
33 32 131
Removing and installing / replacing a steering
knuckle / wheel carrier
Remove rear wheel.
Important!
Expand turning lock sufficiently to avoid damaging thread
when releasing collar nut.
Release collar nut, activate handbrake for this purpose.
Installation:
Replace collar nut, oil collar nut/wheel bearing contact surface
lightly and tighten down.
No oil permitted on thread of shaft journal or collar nut.
Tightening torque 33 41 3AZ
.
Secure collar nut by positive peening on flat areas of output shaft.
Remove rear brake disk.
Disconnect handbrake Bowden cable from expander lock.
Replacement only: Drive out drive flange for rear axle shaft
Remove pulse generator.
Remove stabilizer link from stabilizer.
Remove spring strut shock absorber from wheel carrier.
Remove integral link.
Important!
Risk of damage!
Do not drive output shaft out of drive flange with an impact
tool.
Press output shaft out of drive flange.
Remove guide arm from wheel carrier.
Remove upper control arm from wheel carrier and remove wheel
carrier.
Replacement:
•
Modify rear wheel brake
•
Install new wheel bearing
•
Modify drive flange
RA Removing and installing / replacing a steering knuckle / wheel carrier
BMW AG - TIS
05.02.2013 19:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -