6 Series E64 650i (N62TU) CONVER
51 14 110
Removing and installing/replacing rear model
designation
Important!
The "Instructions for number/letter combination cementing"
serve as the basis for these repair instructions and must be
followed without fail.
Fitting dimensions (E63, E64):
Stick on adhesive tape (1) up to top edge "A". Mark measurement "B" from edge of rear lid (2) on adhesive
tape (1).
Dimensions:
E63, E64 (without M6)
A = 50 mm
B = 36 mm
M6
A = 45 mm
B = 54 mm
Note:
Measurements C, D, E and F are for information purposes only, as determined by carrier film.
630 i, 650 i: C = 6 mm, D = 7.0 mm, E = 22 mm
RA Removing and installing/replacing rear model designation
BMW AG - TIS
05.02.2013 21:44
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
