6 Series E64 650i (N62TU) CONVER
54 34 280
Removing and installing/replacing rear
window module
Necessary preliminary tasks:
•
Remove air outlet trim grill
•
Remove rear side trim panel
•
Convertible top must be correctly adjusted
Open convertible top compartment lid until all hydraulic cylinders
are extended.
Support convertible top compartment lid in service position.
Unlock and disconnect lower plug connection (1) on right side of
vehicle.
Disconnect cable straps.
Release screws and set down hydraulic unit to one side.
Installation:
Replace Torx screws and insert with Loctite.
RA Removing and installing/replacing rear window module
BMW AG - TIS
05.02.2013 23:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
