6 Series E64 650i (N62TU) CONVER
Replacement only:
•
Disengage Bowden cable for unlocking convertible top
•
Remove hydraulic cylinder for convertible top compartment lid
Adjusting kinematics box
Note:
Kinematics box must not be at top dead center.
Insert screws (1).
It must still be possible to slide the kinematics box (2).
Note:
This prevents the kinematics box from jamming.
Check Bowden cables for emergency release mechanism for ease
of movement.
Pull kinematics box to bulkhead.
Tighten nut (1) to 0.5 Nm.
Close convertible top compartment lid via convertible top
actuation.
Note:
The kinematics box engages when the convertible top
compartment lid is closed.
Check Bowden cable for emergency release mechanism for tight
seating.
RA Removing and installing kinematics box
BMW AG - TIS
05.02.2013 23:59
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -